The jETi (JENTEK Eddy Current Tester, Integrated) is an integrated portable nondestructive testing focused system. It is formatted similar to conventional commercial eddy current systems.  While it uses the same internal electronics as the jET, the jETi includes a fully capable Windows computer and typical computer interfaces, with a touch screen.  It weighs less than 7 lbs. and is powered through wall power or built-in batteries. It runs JENTEK’s GridStation software and enables portable and stand-alone operation of the same range of applications as the jET.

Specifications: 7-Channels, support for MWM-Array eddy current sensors and MWM single channel sensors, up to three frequency simultaneous data acquisition from 2.5Hz to 20MHz (depending on material and application needs), up to 7 channels of impedance measurement simultaneously (including real and imaginary parts of the impedance simultaneous), works with JENTEK GridStation software to perform calibration (typically in air following ASTM E2338 and E2884) and process data using JENTEK’s Multivariate Inverse Methods (MIMs) for rapid analysis.

Applications Include: bolt-hole inspection for cracks, surface and subsurface crack detection, weld inspection, coating thickness measurement and coating characterization, corrosion imaging (surface and subsurface), carbon fiber composite quality and damage imaging (for fiber damage only), characterization of ferrous and nonferrous metals, unique capability to support relatively rough surfaces with minimal surface preparation.

---